Always cover your wire connections to keep them secure, clean, and away from other wires. Electrical tape or heat-shrink tubing.Most cameras and displays come with enough connectors to install everything, but if you need to cut a wire or redo a connection, having a variety pack of connectors can save you from a mid-project trip to the hardware store. Use plastic tools near anything delicate. Removing little trim pieces with a screwdriver or metal blade can mar plastic or scratch paint. Flathead and Phillips-head screwdrivers-you’ll come across something that needs to be popped out or unscrewed somewhere along the way.A simple set for under $30 should do the trick. At minimum, you’ll need to disconnect the negative terminal on your battery, and you may need to loosen a taillight or other part. A basic socket-wrench set or open-end wrench set.If not, get some that can easily strip the ends of smaller, 24- and 26-gauge wire, too. Small-gauge wire strippers 22-gauge will do, if you have them.About two to four hours of free time, and a bit of moxie. Most DIYers shouldn’t bother with flush-mount cameras-they’re best left to professional installers. In some situations, such as on a truck’s tailgate, this kind of camera can be the best solution, but it requires drilling a visible hole into your vehicle, and it leaves no margin of error in determining the vertical angle of the camera: If the surface you drill into leaves the camera pointing too high or low, you’re stuck with it. Flush-mount installations: You insert this type into a car-body part, such as a bumper or a trunk lid.Depending on the model, you attach a center mount with simple clips, adhesive strips, or more-permanent screws.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |